This is for 1 DualSense Edge Module that has been Upgraded to Guli-kit TMR Drift Resistant joysticks. Calibration board was also used to calibrate the new stick for optimized performance.
- TMR Guli-kit Module - These can have small mechanical tolerances of +/-0.01 or .+/-0.02 when centered on both axes. - This is considered within range and not a defect.
- Gulikit Joystick with removable cap.
- Calibration Board installed. 2-3 ms delay which is undetectable.
- Calibrated after installion. Calibration will have full circularity and verified 3% to 10% Err Rate. Due to Game settings its best to have the error rate in between this range. Lower error rates would lead to sticks not picking up in game.
Although the TMR sensors should never drift, there is a mechanical tension spring inside the module that will wear out over time/use. This can lead to off centering - slighty adjusting deadzone should resolve this issue if it occurs.
PLEASE READ RETURNS AND WARRANTY SECTION BEFORE ORDERING!
Reviews
I bought a single TMR module for my Dualsense Edge controller from JayfixesIT roughly two weeks ago now and it was honestly the best investment for my setup I’ve made. I got sick and tired of constantly replacing edge modules because of the fact that intense play causes drift for me in about a month. So far I’ve had 0 issues out of the module and I wish I would’ve went ahead and got both. My aim has become a heck of a lot more stable and consistent. All I can say is you’d be surprised how much it will enhance your precision. I really just expected to be about the same minus the drift but the TMR is infinitely better than the standard ALPS potentiometers they put in first party controllers. Thanks again my good man!
VON
W’s ALL AROUND